This is the PICkit 4, the official programmer from Microchip. The PICkit 4 allows debugging and programming of PIC®, dsPIC®, AVR, SAM and CEC flash microcontrollers and MPUs using the powerful graphical user interface of the MPLAB X Integrated Development Environment (IDE). The MPLAB PICkit 4 is connected to a PC using a high-speed 2.0 USB interface and can be connected to the target via an 8-pin Single In-Line (SIL) connector. The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming™ (ICSP™). An additional micro SD card slot and the ability to be self-powered from the target means you can take your code with you and program on the go. Comes with a USB to micro-B USB cable.

• MPLAB PICkit 4 In-Circuit Debugger/Programmer
• USB to micro-B USB cable
• Warranty card
• 2 MPLAB PICkit 4 stickers

• Powered by a high-speed USB 2.0, no external power required
• Real-time execution
• MPLAB X IDE compatible (free copy included)
• Built-in over-voltage/short circuit monitor
• Firmware upgradeable from PC/web download
• Fully enclosed
• Target voltage of 1.20V to 5.5V
• Can supply up to 50mA of power to the target
• Minimal current consumption at <100µA from target
• Diagnostic LEDs (power, busy, error)
• Read/write program and data memory of microcontroller
• Erase of program memory space with verification
• Freeze-peripherals at breakpoint
• 8-pin single in-line header supports advanced interfaces such as 4-wire JTAG and Serial Wire Debug with streaming Data Gateway
• Backward compatible for demo boards, headers and target systems using 2-wire JTAG and ICSP

• User's Manual
• Quick Start Guide
• MPLab X IDE
• Product Page