×
It's Cyber Monday all week long! Use promo code BFCM2023 at checkout for 15% off SparkFun Original Products under $200. Some exceptions apply. Shop SparkFun Originals.
- Home
- Product Categories
- Wire
- Jumper Wire - 0.1", 6-pin, 4"
This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.
- 4" length
Jumper Wire - 0.1", 6-pin, 4" Product Help and Resources
Large Digit Driver Hookup Guide
June 25, 2015
Getting started guide for the Large Digit display driver board. This tutorial explains how to solder the module (backpack) onto the back of the large 7-segment LED display and run example code from an Arduino.
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
No reviews yet.
You guys should sell a kit of just the connectors, a bunch of crimps and headers. I know I would buy that in a second
What is the maximum recommended current?
Check out this forum post: https://forum.sparkfun.com/viewtopic.php?f=14&t=42159
The last three entries should help.