Description: This is a Hardware Pack for the Intel® Edison, with this set you will be provided with increased mechanical strength for stacking Blocks. Each Hardware Pack includes ten M2x3mm standoffs, six M2x3mm screws, and six M2 nuts. With this set of hardware you will be able to secure three Blocks to one Intel® Edison. Eight standoffs and four screws and nuts are used for the Blocks, while two standoffs, screws, and nuts are used for the Intel® Edison itself.
If you are looking to give your Intel® Edison stack a little more stability, this Hardware Pack is perfect for you!
Based on 9 ratings:
1 of 1 found this helpful:
Recently purchased a few packs and they all fit nicely. Did not run into any issues as others have seen in the past.
1 of 1 found this helpful:
the threaded ends vary in length some fit some don’t.
Sorry for the issue. We’ll try to work with our supplier to see if we can clean up this discrepancy. Happy hacking
2 of 2 found this helpful:
These are nice brass standoffs. Unfortunately, the male portion is too long, and the Edison boards are too thin. This results in the standoffs being loose on the boards, and making the stack a bit too thick.
The solution is to use a Dremel and ViceGrips to trim off the tip of each standoff, which is a tedious solution at best. I tried to cut off about 1 cut-off wheel width. Don’t forget to give it a pass with a file to clean up the threads.
Once you trim the standoffs they work fine.
Sparkfun recommends “you will need to torque the screws down”. I tried that, and ended up breaking three of mine. And the standoffs weren’t even tight against the PCB.
Hi, So sorry to hear about this issue you ran into. Thank you for the helpful feedback and suggestions. We’ll look into this and see if something has changed, or if there is anything we can do to help this matter in the long run. Thanks
The screw part of the standoff seem overall too long.
For a customer product based on Edison we have build over 50 stacking Blocks. The only one problem we have was when we loose somewhere a screw.
Hey, Sparkfun! So, this hardware kit isn’t too great for holding several Edison blocks together. The internal threaded parts of the standoffs are too short for the screws to fully tighten (or the threaded parts of the screws are too long). The bodies of the standoffs are also a bit wide. The edges of the standoffs actually touch the zif connector on the blocks, which makes the blocks look a bit skewed when assembled. Lastly, the nuts come DANGEROUSLY close to one of the capacitors next to the bottom-right screw hole on the Edison itself.
It’s convenient getting the getting all of your hardware delivered at once. If you are purchasing an Edison and Sparkfun boards you might as well buy this.
I highly recommend the Intel Edison to anyone who want an Arduino with the power of a Raspi
Check out my first project @ http://www.instructables.com/id/Smart-Helmet-Intel-Edison-Sparkfun-9DOF/
And please, please be a friend and vote for us!
I guess they would fit if sparkfun’s edison pcb boards were thicker …
I received two hardware packs recently and find the all the male threads too long. This increases gap between blocks and could result in damage to Hirose connectors. Sparkfun may please look into this.
Hi, We have received a new set of hardware that has been modified to be shorter and fit properly. If you have hardware that is to long, please contact us at firstname.lastname@example.org and we’ll be happy to help.