9V Snap Connector

Classic 9V snap connector terminated with 2-pin polarized Molex connector with 0.1" spacing. The cable is 26AWG and is 5" in length.

9V Snap Connector Product Help and Resources

Core Skill: Electrical Prototyping

If it requires power, you need to know how much, what all the pins do, and how to hook it up. You may need to reference datasheets, schematics, and know the ins and outs of electronics.

1 Electrical Prototyping

Skill Level: Noob - You don't need to reference a datasheet, but you will need to know basic power requirements.
See all skill levels


Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • eewestcoaster / about 12 years ago / 3

    What connector would you use with this to connect it to your board?

  • BetterSense / about 11 years ago / 2

    It would be nice to know the wire gauge. I would like to use this for a battery pack that supplies over an amp.

  • What is the wire gauge on this?

  • Member #241469 / about 11 years ago / 1

    Hi
    Can I use it with Android IOIO http://www.sparkfun.com/products/10748?
    Regards,
    Pablo Cantero

    • Yes, you would need headers to connect to the IOIO, or just cut the wires and solder them directly to the board.

  • BigBen1861 / about 12 years ago / 1

    Would you consider selling this without the barrel connector on it, like in the PICAXE 8 Pin Proto Kit? I'd like to simply solder the leads to my PCB.

Customer Reviews

5 out of 5

Based on 1 ratings:

Currently viewing all customer reviews.

2 of 2 found this helpful:

Quick Connecting

When creating small circuits on a solderable breadboard I'll often attach 2 header pins in order to connect up a power source. I then use this to quickly attach a power source.