Breadboard Arduino Compatible Parts Kit Add-On

Replacement:DEV-10909. This board is now part of our RedBoard lineup of Arduino-compatible boards and kits. This page is for reference only.

Have you already built your Arduino-Compatible Breadboard Kit but want to make it more permanent? This kit allows you to take all of the parts you already have from the Arduino-Compatible Breadboard Kit and, with some through-hole soldering, turn them into a shield-compatible development board!

Note: This kit is intended as an add-on to the Arduino-Compatible Breadboard Kit. If you don't have the parts from that kit, you will not be able to complete this one. If you haven't made the breadboard version and want to skip straight to the through-hole kit, check out the Arduino-Compatible PTH Kit below.

  • 1 x SparkFun Red PCB
  • 1 x MCP1700 3.3V Voltage Regulator
  • 1 x Diode 1N4001
  • 1 x Resettable Fuse PTC
  • 1 x 28-Pin DIP Socket (To seat your ATMega)
  • 1 x Push Button Reset Switch
  • 2 x 6-Pin Female Headers
  • 2 x 8-Pin Female Headers
  • 1 x 6-Pin Right Angle Header (To connect your FTDI Basic)
  • 1 x 0.1uF Capacitor
  • 1 x DC Barrel Jack



Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Unh0ly_Tigg / about 12 years ago / 1

    I would like it if you guys sold the 3.3 voltage regulator that is in this kit by its self.

  • santafeham / about 12 years ago / 1

    would you consider selling just the PCB? If so how much would it cost?

Customer Reviews

No reviews yet.