Papilio Audio Wing

The Papilio Audio Wing is a fast and easy way to snap into audio capability. Plug the Audio Wing into your Papilio FPGA board and you’ll have two stereo channels on two 1/8" jacks. The detect pins are also broken out so that your Papilio board can sense when an audio connector is plugged in.

Note: This product is a collaboration with Jack Gasset. A portion of each sale goes back to him for product support and continued development.

  • Delta-Sigma ready for high quality stereo output.
  • Two stereo channels with left and right outputs.
  • Two 1/8" stereo jacks.
  • Low pass RC filter.
  • Connection sensor pin to detect when speakers are connected.

Papilio Audio Wing Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels


Core Skill: Electrical Prototyping

If it requires power, you need to know how much, what all the pins do, and how to hook it up. You may need to reference datasheets, schematics, and know the ins and outs of electronics.

2 Electrical Prototyping

Skill Level: Rookie - You may be required to know a bit more about the component, such as orientation, or how to hook it up, in addition to power requirements. You will need to understand polarized components.
See all skill levels


Customer Comments

  • Can we get a part number for the audio connectors? Also, please start offering these for sale - the long thin footprint works a lot better for my designs than the one you guys currently have available. Thanks!

  • I found this device to be very helpful in constructing a simple audio mixer. I wrote up the details in this github repository.

Customer Reviews

No reviews yet.