Board to Board Double Slot Female Connector - 50 pin, 0.5mm

These are the surface mount 50 pin 0.5mm Board to Board Double Slot Female Connectors found on the Alchitry FPGA boards. These headers allow for Alchitry FPGA Boards to stack on one another by being soldered to the topside of the board.

These connectors are sold in single units. Four of these connectors are needed for the underside of an Alchitry Board.

Board to Board Double Slot Female Connector - 50 pin, 0.5mm Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

3 Soldering

Skill Level: Competent - You will encounter surface mount components and basic SMD soldering techniques are required.
See all skill levels


Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • dpitchfo / about 6 months ago / 1

    Looking at the datasheet for the the male connector (PRT-16890), the drawing is miss leading for the PCB Layout. The embossed alignment hole is on the wrong side. If you look at the side view, it shows the correct location for the emboss pin, but the schematic view needs to be rotated 180 degrees.

  • dpitchfo / about 7 months ago / 1

    The link to the drawing for the connector is not working.

Customer Reviews

No reviews yet.