×

In celebration of the 50th anniversary of Apollo 11's Moon Walk, we are offering $50 off our SparkFun Inventor's Kit for RedBot and the Arduino Engineering Kit while supplies last! Use promo code APOLLO11 at checkout until 11:59 p.m. MT to get yours today!

Molex Jumper 3 Wire Assembly

This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin Molex connector with 0.1" spacing on one end, bare cable on the opposite end. It also comes with the mating connector for the Molex.

  • 6" length

Molex Jumper 3 Wire Assembly Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels


Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • As it happens, this is the same type of connector found in PC fans

  • Now that this item has been retired, will there be something nearly identical to take its place?

  • The datasheet doesnt show any dimensional information.

    What is the width of the square leads on the connector end?

  • Hi, what is the part number for the male and female Molex connectors used in this cable assembly?

  • in the photo with the black background, what is the item with the three prongs called? is that the mating connector that comes with it?

  • Wow, I wish I'd seen these before buying the jst jumper assemblies. Easier mechanical operation and 0.1" spacing!

Customer Reviews

No reviews yet.