Engy
Member Since: May 13, 2010
Country: United States
Profile
Bio
B.S. M.S Mechanical Engineer, B.S. Electrical Engineer
Programming Languages
C, Matlab, Labview
Universities
Ohio University Ohio University University of Kentucky University of Kentucky
Expertise
Mechatronics & Motors
Interests
Motors
-
I really like this sensor, I just wish that there was a solder jumpers to disable the pull up resistors like on the BMP180 breakout. It wasn’t much hassle to simply remove the resistors though; I just dislike putting 0603s back.
-
Rex’s food now gets a chase montage.
-
Am I the only one concerned about the ramp having a slope of ~8.4 deg? (Wheelchair ramp code is ~4.8 deg) My poor little robot won’t have enough power beyond a crawl.
-
Lucky’s nemesis grumpy cat thinks trees are good place for a lair…
-
Striving to be man’s best friend, Lucky attempts to learn ‘ladder logic’
-
Horton solders a who!
-
Look at this hat… where’s a blue shell when you need one.
-
“‘Ooh! Scary! Scary! Don’t we look mean?’ he said, now I have to go talk to HR…again”
-
whelp… Grrr.
-
I really Like this board except for two things:
(1) The serial TX/RX pins opposite of the USB only does 3.3V and not the selected VCCIO. This very annoying in application.
(2) Also I would prefer a real VCCIO jumper opposed to the solder one; even if it made the card bigger. (I change this alot between work & personal stuff.)
Other than those two minor things, this card is amazing.
No public wish lists :(