JST SH Jumper 4 Wire Assembly - 8"

This is a simple four wire cable. Great for jumping from board to board or just about anything else. These cables mate with the connectors listed below. They have bare wires on one end and a 4-pin JST SH connector on the other end with a mating socket.

  • 8" length

JST SH Jumper 4 Wire Assembly - 8" Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels


Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Member #427941 / about 11 years ago / 1

    How can I order only the JST connectors? I need both male and female.

Customer Reviews

4.7 out of 5

Based on 3 ratings:

Currently viewing all customer reviews.

1 of 1 found this helpful:

Sure beats crimping those tiny connectors

After many failed attempts at crimping those tiny connectors, these pigtails were a godsend. Thank you so much for offering them!

Shouldn't have to buy this separately but...

I used this with the fingerprint scanners from sparkfun. I really think this should've come with the scanners since they can't be used without this cable. The cable did what its supposed to do though. Would've been nice if the wires were slightly heavier duty like 22 AWG instead of 28 to make soldering a little easier.