Last week, we released four new boards featuring the BMA400 from Bosch as well as the LPS28DFW from STMicroelectronics. Today, we are going to take a closer look at each of these chip sets!

Continue reading

The BMA400 and LPS28DFW receive both Standard-sized and Micro-sized Qwiic board versions!

Continue reading

Three new Machinechat Kits are now available from SparkFun Electronics! Also, be sure to pick up your limited edition Constellation Kit while supplies last!

Continue reading

This week the BMP581 Pressure Sensor and ISM330DHCX 6DoF IMU get the Qwiic treatment!

Continue reading

The BMP384 Pressure Sensor is the newest board to join the Qwiic ecosystem but don't forget about our new RP2040 options, too!

Continue reading

A new BME688 Sensor is now available along with a Raspberry Pi Pico Display Kit and the new Oak-D LITE!

Continue reading

Tags


All Tags

Recent Blog Comments

What a cool thing 20 years! My first time seeing SparkFun was at MakerFaire in San Mateo, CA. So much fun talking and buying stuff, I wanted…

I think my favorite memory of Sparkfun was when I took the tour of the facility (I think it was either 2017 or 2018), and met a few of the…

Like so many projects I've tried to undertake using SF products. I repeat the procedures as written only to find that something that is…

To share a point of amusement: Last year I put together a presentation on the Apollo Guidance System that took men to the Moon in 1969. Due…

Hmm. Looking through this blog post, it looks like Alex left the 3D models for the case in the GitHub repo for anyone to print =>…

Where can I get the case? It is nice to see the hardware for a UI for a project but I want the case to put it into. It looks like the case…

Nice catch. I just fixed it. It should be pushed by the end of today to reflect the new firmware v01.00.02. ;D

Easy EDA does some wacky things if your doing a double sided board and you place different components on the same X and Y but on different…

In addition to KiCad, I've also used gEDA and [been ab]used [by] Eagle. gEDA was an "open source" solution, mainly used on Linux, but last I…

Great question! Yes, there is: at the top right-hand side of the designer you'll find a little file icon with a "G" on it that will allow…

Recent Authors

One Chris Two Chris Red Chris Blue Chris

[redacted]

-KJB-

Mariah

Chowdah

MAKIN-STUFF

jahnell

Glenn S

Nate

ROB-24601

Graceflix

SparkFro

Juno Presken

Gior Dior

Haileyasaurus


All Authors