STEM week has launched with deals up to 20 percent off! Make sure to hurry before some deals run out.
Just because Maker Faires, conferences, and summits have been cut down to a minimum doesn't mean you can't continue to expand your circle of like-minded maker friends. Here are a few suggestions for folks that you may want to follow (if you aren't already).
The new Qwiic OpenLog Kit is now available, along with a new Qwiic Cellular Notecarrier. Be sure to check out the new Otto DIY Kits, as well!
We're back with another remote micro:bit learning session!
We hosted a webinar that shows you how to teach students all about micro:bit in less than one hour.
Looking to get your kids into programming? Look no further!
Recently, a team from the St. Vrain Innovation Center assembled its first custom PCB design with the help of SparkFun. This is the story behind their project and their experience.
Rocky Mountain STEAM Fest gives attendees the chance to learn by playing
SparkFun proudly supports annual STEAM event
Celebrating women in STEM since 1815
We all know that women are not only a minority in technical fields, but are often not encouraged to go into such fields. Here are a few ways to encourage and support the girls/women in our lives who are interested in technical fields.
Like so many projects I've tried to undertake using SF products. I repeat the procedures as written only to find that something that is…
To share a point of amusement: Last year I put together a presentation on the Apollo Guidance System that took men to the Moon in 1969. Due…
Hmm. Looking through this blog post, it looks like Alex left the 3D models for the case in the GitHub repo for anyone to print =>…
Where can I get the case? It is nice to see the hardware for a UI for a project but I want the case to put it into. It looks like the case…
Nice catch. I just fixed it. It should be pushed by the end of today to reflect the new firmware v01.00.02. ;D
Easy EDA does some wacky things if your doing a double sided board and you place different components on the same X and Y but on different…
In addition to KiCad, I've also used gEDA and [been ab]used [by] Eagle. gEDA was an "open source" solution, mainly used on Linux, but last I…
Great question! Yes, there is: at the top right-hand side of the designer you'll find a little file icon with a "G" on it that will allow…
One quick question that I didn't see answered in the above: Is it possible to get this to create Gerber files for the newly designed board?…
I think my favorite memory of Sparkfun was when I took the tour of the facility (I think it was either 2017 or 2018), and met a few of the…